HSB Beta 100-D-ZSA, Оригинальное руководство по сборке и обслуживанию

Страница: 21 / 38

Installation and adjustment
FM 239 MuW Beta Type Z Rev.01 2022-09-01
19
distributed by
6.2 Screwing the linear unit into place from below
Figure 4: Sliding blocks (1) in the groove on the underside of the base profile
Attach the linear unit by the fixing screws from below using the sliding
blocks or the tapped hole rails in the aluminium base profile (figure 3).
Procedure 1.
Align the linear unit.
2.
Align the sliding blocks (1)/tapped hole rails.
3.
Tighten the linear unit
(for tightening torques see section 3).
6.3 Setting maximum travel
Serious injury may result if the transport carriers topple over.
If the carriage moves to its full extent beyond the safety zone, the
transport carrier mounted on it may break away or topple over. The
linear unit may be destroyed
During setup, observe the specified safety zone and set the limit
switches accordingly.
Electrical switches may only be connected by qualified electricians.

To stop the carriage promptly in the event of an emergency stop,
allow for adequate braking distance.