Page 10
Huddle Hub Installation Guide
3.4 Rear Panel
Power supply
Plug the power cord to the AC-DC power supply and connect the power supply to the DCIN
connector. Connect the power supply to the wall socket.
Verify that the green LED on the front panel is on and solid to confirm that the hardware is connected
correctly.
Network port
The network connector is a standard RJ45 and the network interface is a Gigabit Ethernet standard.
Connect HHO to the company LAN using an Ethernet cable (not supplied).
Warning: Use shielded cat 6 SSTP Ethernet cable to connect HHO to the company LAN.
Tip: HHO must be connected to Internet to allow it to download the latest release of its software.
Restore button
This button has two functions:
Reset procedure: resets the configuration to the default parameters, discarding all current settings.
The internal software is not reinstalled and the firmware version does not change.
Restore procedure: wipes the current firmware and does a full firmware re-installation. The
firmware version changes to the one originally installed on the unit (and it's then updated if connected
to the internet).
Please see the Configuration Guide for details about the Reset and Restore procedures.
