T-Lock Call Blocker User Manual
Last revised on June 10, 2015 by HQTelecom.com
Congratulations on your purchase! This document provides instructions on how to setup,
install, and program your Call Blocker.
Packing content:
Your packaging contains the following
items:
(1) T-Lock Call Blocker Call Blocker device
with LCD display, 6 buttons (SET, OUT,
BLACKLIST, REMOVE, UP & DOWN (
◄
or
►
) buttons), and two RJ-11 sockets (TO
LINE, TO PHONE).
(1)Telephone cord
(1) Wall / Desktop bracket
(1) User manual
Quick Setup:
This device is powered by your phone line. Simply plug-in your Call Blocker to an existing
phone jack (or modem) in series or parallel (as shown below) and wait for calls to start ringing.
Then follow the instructions under the ‘Getting Started’ section below to start building your
BLACKLIST. It’s that simple!
IMPORTANT: Please make sure your phone line has ‘Caller ID service’ active. Your Call Blocker
will not work properly without it. If you are not sure, please contact your telephone service
provider.
Installation:
There are 2 ways of installing your T-Lock Call Blocker as shown below. Your call blocker
should work in both settings, however we recommend that you test both to find out the best
setup for you.
SERIES INSTALLATION:
PARALLEL INSTALLATION:
