LED name
LED color
Status of hardware
Recommended action
Power supply
and fan
assembly
status LED
No light
Power supply and fan assembly
is off or not receiving power.
Verify the power supply and fan
assembly is on and seated correctly,
and the power cord is connected to a
functioning AC power source.
Steady green
Power supply and fan assembly
is within the operational range.
No action is required.
Flashing
green (5
seconds)
Indicates one of the following:
• The assembly is switched off
(flashing for ~ 5 seconds,
then off).
• The power cable is
disconnected (flashing for ~
5 seconds, then off).
• The power supply and fan
assembly has failed.
NOTE:
When the device is first
powered on, the power
supply and fan assembly
status LED flashes until
POST has completed.
• Check the power cable
connection.
• Verify that the assembly is
powered on.
• Replace the power supply and
fan assembly.
QSFP port
status LED
(HPE
StoreFabric
SN6600B
32Gb FC
Switch only)
No light
Indicates one of the following:
• There is no light or signal
carrier on the media
interface.
• Device may be initializing
• Connected device is
configured in an offline state.
• Verify the power LED is on, and
check the QSFP and cable.
• Verify the device is not being
initialized.
• Verify the status of the connected
device.
Steady amber Port is receiving light or signal
carrier, but not online.
No action is required
Slow blinking
amber (2
seconds)
Either the port has been
disabled by diagnostic tests
running or was disabled from
executing the
portdisable
CLI command.
Verify the diagnostic tests are not
being run. Re-enable the port using
the
portCfgPersistentDisable
command.
Fast blinking
amber (1/4
second)
Port is online and an internal
loopback diagnostic test is
running.
No action is required.
Fast blinking
amber (1/2
second)
QSFP or port is faulty.
• Reset the port.
• Replace the QSFP. Must be a
Brocade-branded QSFP.
Table Continued
Login and Configuration
27
