a.
Clean the indentations at each corner on the bottom of the switch to ensure that they are free of
dust or other debris.
b.
With the adhesive side against the chassis, place one rubber foot in each indentation and press
into place.
3.
Place the switch on a flat, sturdy surface.
4. HPE StoreFabric SN3600B 32Gb FC Switch
-Connect the power cord to the power supply present.
Power is supplied to the switch as soon as the power cord is connected to the switch and power
source. There is no power switch on the power supply.
HPE StoreFabric SN6600B 32Gb FC Switch
- Connect the power cords to both power supplies and
then to power sources on separate circuits to protect against AC failure.
Ensure that the cords have a minimum service loop of 6 inches available and are routed to avoid
stress.
5. HPE StoreFabric SN6600B 32Gb FC Switch only
-Power on the power supplies by setting both AC
switches to the on (
|
) position.
The power supply LEDs are amber until POST is complete, and then change to green. The switch
takes several minutes to boot and complete POST.
NOTE:
•
HPE StoreFabric SN3600B 32Gb FC Switch
-Power is supplied to the switch as soon as the
power cord is connected to the switch and power source. There is no power switch on the
power supply.
•
HPE StoreFabric SN6600B 32Gb FC Switch only
-Power is supplied to the switch as soon
as the first power supply is connected and turned on.
6.
After POST is complete, verify the switch power and status LEDs on the port side of the switch are
green.
Setup and install
15
