16.
Install the access panel.
17.
Install the server.
Removing and replacing the battery
If the server no longer automatically displays the correct date and time, then replace the battery that provides
power to the real-time clock. Under normal use, battery life is 5 to 10 years.
WARNING:
The computer contains an internal lithium manganese dioxide, a vanadium pentoxide, or an
alkaline battery pack. A risk of fire and burns exists if the battery pack is not properly handled. To reduce
the risk of personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60°C (140°F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
• Replace only with the spare designated for this product.
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
on page 29).
6.
Remove the air baffle (
on page 30).
7.
Remove the rear support bracket (
Removing the rear support bracket
on page 31).
8.
Remove the battery.
44
Removal and replacement procedures
Содержание ProLiant XL230k Gen10
