HPE ProLiant BL460c Gen10, Руководство пользователя

Страница: 26 / 101

2. If removed, install the internal USB drive.
To locate the internal USB connector, see System board components on page 13.
3. If removed, install the direct connect SATA cable ( Install the direct connect SATA cable on page
31.
4. Install the access panel on page 23.
5. Install the server blade on page 42.
6. Power up the server blade on page 21.
Remove an M.2 SSD from the M.2 riser board
Prerequisites
To remove an M.2 SSD from the M.2 riser, you need a No. 1 Phillips screwdriver.
Procedure
1. Power down the server blade on page 21.
2. Remove the server blade on page 22.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel on page 22.
5. Remove the left DIMM baffle from the server blade ( Remove the DIMM baffles on page 23).
6. Remove the M.2 SSD from the M.2 riser board. Use a No. 1 Phillips screwdriver to disengage the
screw.
26 Operations