33
Figure 28 Connecting the AC power cord to the PSR6000-ACV
Connecting the PSR320-D/PSR650-D
CAUTION:
•
When connecting the DC power cord to the DC wiring terminals, make sure the circuit breaker at the power
input end is off.
•
The power cord color code scheme in Figure 29 is for illustration only. The cable delivered for your country
or region might use a different color scheme. When you connect a power cord, always identify the polarity
symbol on its wires.
The procedures for connecting power cords for the PSR320-D and PSR650-D are similar. This
section uses the PSR650-D as an example.
To connect the PSR650-D:
1.
Remove the protection cover from the power supply.
2.
Loosen the captive screw on the wiring terminal with a Phillips screwdriver.
3.
Connect the wire marked with the negative polarity symbol (
–
or
L–
) to the negative terminal (
–
)
on the power supply.
4.
Connect the wire marked with the positive polarity symbol (
+
or
M/N
) to the positive (
+
) terminal
on the power supply.
5.
Put the protection cover on the wiring terminals.
6.
Connect the other ends of the wires to the DC power source wiring terminals, with the negative
wire (
–
or
L–
) to the negative terminal (
–
) and the positive wire (
+
or
M/N
) to the positive terminal
(
+
).
