HPE FlexNetwork 7500 Series, Справочник команд управления и мониторинга сети

Страница: 70 / 430

61
the lost packets is checked against the threshold. If the number reaches or exceeds 100, the state of
the reaction entry is set to over-threshold. Otherwise, the state is set to below-threshold. Once the
state of the reaction entry changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element packet-loss
threshold-type accumulate 100 action-type trap-only
reaction checked-element probe-duration
Use reaction checked-element probe-duration to configure a reaction entry for monitoring the
probe duration.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element probe-duration threshold-type { accumulate
accumulate-occurrences | average | consecutive consecutive-occurrences } threshold-value
upper-threshold lower-threshold [ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entry for monitoring the probe duration is configured.
Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP operation view
ICMP/UDP echo operation view
Predefined user roles
network-admin
mdc-admin
Parameters
item-number : Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-type : Specifies a threshold type.
accumulate accumulate-occurrences : Checks the total number of threshold violations. The value is
in the range of 1 to 15.
average : Checks the average probe duration.
consecutive consecutive-occurrences : Specifies the number of consecutive threshold violations
after the NQA operation starts. The value is in the range of 1 to 16.
threshold-value : Specifies threshold range in milliseconds.
upper-threshold : Specifies the upper limit in the range of 0 to 3600000.
lower-threshold : Specifies the lower limit in the range of 0 to 3600000. It must not be greater than the
upper threshold.
action-type : Specifies what action to be triggered. The default action is none .
none : Specifies the action of displaying results on the terminal display.
trap-only : Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS. This keyword is not available for the DNS operation.