41
If the NQA client can receive the Access-Accept packet from the RADIUS server, the authentication
service is available on the RADIUS server. Otherwise, the authentication service is not available on
the RADIUS server.
Before you configure the RADIUS template, specify a username, password, and shared key on the
RADIUS server. For more information about configuring the RADIUS server, see
Security
Configuration Guide
.
To configure the RADIUS template:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a RADIUS
template and enter its
view.
nqa
template
radius name
By default, no RADIUS templates exist.
3.
(Optional.) Specify the
destination IP address of
the operation.
•
IPv4 address:
destination ip
ip-address
•
IPv6 address:
destination ipv6
ipv6-address
By default, no destination IP address is
configured.
4.
(Optional.) Specify the
destination port number
for the operation.
destination port
port-number
By default, the destination port number
is 1812.
5.
Specify a username.
username username
By default, no username is specified.
6.
Specify a password.
password
{
cipher
|
simple
}
string
By default, no password is specified.
7.
Specify a shared key for
secure RADIUS
authentication.
key
{
cipher
|
simple
}
string
By default, no shared key is specified for
RADIUS authentication.
8.
(Optional.) Specify the
source IP address for the
probe packets.
•
IPv4 address:
source ip
ip-address
•
IPv6 address:
source ipv6
ipv6-address
By default, the packets take the primary
IP address of the output interface as
their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
Configuring the SSL template
A feature that uses the SSL template performs the SSL operation to measure the time required to
establish an SSL connection to an SSL server.
Before you configure the SSL template, configure the SSL client policy. For information about
configuring SSL client policies, see
Security Configuration Guide
.
To configure the SSL template:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an SSL template
and enter its view.
nqa template ssl name
By default, no SSL templates exist.
