5. Click Apply.
The iSM connects to the WiFi.
6. Optional: To force a new check for available WiFi networks, click Scan.
7. Optional: To manually add a nonbroadcasting SSID, click Add WiFi.
Configuring WiFi Access Point settings
Prerequisites
iSM Admin privilege
Procedure
1. Click Wired and Wireless Network in the navigation tree, and then click the WiFi AP tab.
The WiFi Access Point page appears.
2. Use Enable/Disable to control the state of the WiFi access point.
3. Enter a SSID.
4. Click Apply.
NOTE:
• When connecting to the access point, you will be required to enter your iSM credentials. Credentials are case sensitive.
• The use of the WiFi AP is used only for initial configuration of iSM.
• Enabling or disabling the access point may cause iSM network connections to become unresponsive for 10 seconds.
Configuring LTE settings
iSM can connect to an LTE network to provide cellular data access to the user interface.
NOTE: When disabling and then re-enabling the APN, there is a delay before the settings are restored and appear on the page.
Wait until the settings reappear before continuing.
Procedure
1. Enable the APN.
2. Enter the APN (Access Point Name) to present to the carrier.
3. Enter the IMEI (International Mobile Equipment Identity).
4. Enter the IMSI (International Mobile Subscriber Identity).
5. Enter IP.
The default bearer unique IP address for the APN can be an IPv4 or IPv6 address.
Finding the wireless broadband modem (LTE) settings in Microsoft Windows
If you need to find the settings to complete the LTE Configuration in iSM, follow this procedure.
70 Configuration
