• T-15 security screwdriver
• Phillips screwdriver
Procedure
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the server on a flat, level surface with the top cover facing down.
5. Remove the antennas on the system.
6. Remove the installed bracket option.
7. Remove the security cover:
a. Remove the screws securing the security cover.
b. Detach the pins of the security cover from the system, and then remove the security cover.
Installing the security cover
Prerequisites
Before you perform this procedure, make sure that you have the Phillips screwdriver available.
52 Associated hardware procedures
