HPE Aruba 3810, Руководство по мультикастингу и маршрутизации

Страница: 364 / 456

Enabling event logging
Syntax:
[no] bgp log-neighbor-changes [prefix-list prefix-list-name ]
Enables or disables BGP event logging. Optionally, specify a prefix-list to filter log messages from specific BGP
neighbors only.
Describing a neighbor
Syntax:
[no] neighbor ipv4-addr description desc
Describes a neighbor.
Neighbor configuration and neighbor policy configuration
Table 37: Neighbor configuration and neighbor policy configuration commands
Command syntax Description Default CLI reference
neighbor ipv4-addr
remote-as as-#
no neighbor ipv4-
addr
Adds an entry to the BGP
neighbor table in router
configuration mode.
Adding an entry to the
BGP neighbor table in
router configuration
mode
on page 366
[no] neighbor ipv4-
addr dynamic
Specifies whether to
enable or disable dynamic
capabilities.
Enabling or disabling
dynamic capabilities
on
page 367
[no] neighbor ipv4-
addr updated-
source ipv4-addr
Specifies the IP address to
be used on the local end
of the TCP connection
with the peer.
Specifying the IP
address for local end of
TCP connection with
peer
on page 367
[no] neighbor ipv4-
addr allowas-in
num-loops
Specifies the number of
times this autonomous
system can appear in an
AS path. When not configured, or
when using the no version
of the command, the value
of as-loops is set to its
default value of 1.
Specifying the number
of times the autonomous
system can appear in an
AS path
on page 367
[no] neighbor ipv4-
addr as-override
Causes all occurrences of
our peer’s AS to be
replaced with one from an
export.
Replacing occurrences
of peer's AS with one
from an export
on page
367
Table Continued
364 Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08