4-16
Part replacement procedures
P05957-002
12. Apply new TIM to the GPU module. Use one tube of TIM and apply four dots and an “X”
pattern.
Caution:
Verify that there is no debris or particle contamination in the TIM application. Debris
or particle contamination can cause damage to the GPU. If there is debris or particle
contamination, clean off the TIM and apply fresh TIM.
13. Insert the heatsink over the GPU module.
14. Secure the heatsink with four screws.
–
Tighten the screws in an “X” pattern to 1 in-lb or until finger tight.
–
Repeat the “X” pattern to tighten all screws to 3-4 in-lbs.
15. Install the front top cover.
16. Connect power to the system.
17. Power up the system.
4.4.9 I/O port module (third PCIe riser) replacement
The I/O port module is part of the third PCIe riser. The third PCIe riser is the riser closest to the
power supplies.
Содержание Apollo sx40
