HPE Apollo 6500 Gen10, Руководство пользователя

Страница: 42 / 92

3. Connect the power cord to the power supply.
4. Power up the server ( Power up the server on page 20).
Installing an 8SFF drive cage
For information on supported drives, see Supported drives on page 16.
Prerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
2. Power down the server ( Power down the server on page 20).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Extend the chassis from the rack ( Extending the chassis from the rack on page 20).
5. Remove the access panel ( Removing the access panel on page 23).
6. Remove the drive cage blank.
42 Installing an 8SFF drive cage