HPC MOBILAIR M27 PE, Руководство по эксплуатации

Страница: 158 / 312

5. Insert the plug to close the lubricant filler port.
6. Close the enclosure.
Further information See chapter 2.8.1 for suitable lubricant grade and volume.
10.9.2 Option da
Compressed air aftercooler maintenance
The compressed air aftercooler is located near the air treatment devices. The frequency of clean‐
ing is mainly dependent on local operating conditions.
Check the compressed air aftercooler regularly for clogging.
Severe contaminations should be cleaned by a KAESER SERVICE technician.
Material Compressed air
Breathing mask (if necessary)
Water or steam jet blaster
Precondition The machine is switched off.
Enclosure is open.
The machine has been set down in cleaning area with oil separator,
The machine has been set down on level ground,
the machine has cooled down.
Air consumers are disconnected,
the outlet valves are open,
the machine is fully vented, the pressure gauge reads 0 bar.
The negative cable to the battery is disconnected.
CAUTION
Swirling dust due to cleaning with compressed air!
Illness of the respiratory tract.
➤ Wear breathing mask.
NOTICE
Damage to the machine can be caused by water or steam jets!
Direct water or steam jets can damage or destroy electrical components and indicating in‐
struments.
➤ Cover up electrical components such as the control cabinet, alternator, starter and dis‐
play instruments.
➤ Do not direct water or steam jets at sensitive components such as the display instru‐
ments.
➤ Deploy the extension pole of the pressure washer at a distance of at least 50 cm and at
an approximate 90° angle to the cooler/radiator surface.
NOTICE
Improper cleaning with hard objects!
Damages to compressed air aftercooler.
➤ Do not use hard objects to clean the compressed air aftercooler.
➤ Comply with all instructions!
10 Maintenance
10.9 Maintenance of Optional Items
146
Operating Manual Portable Rotary Screw Compressor
MOBILAIR M27 PE
No.: 9_9548 22 HCE