WARNING!
Do not use the front bezel as a handle or lifting point when lifting or moving the workstation.
Lifting the workstation from the front bezel, or lifting it incorrectly, could cause the workstation to fall,
causing possible injury to you, and damage to the workstation. To properly and safely lift the workstation,
lift from the bottom of the workstation for either the desktop or minitower configuration.
Cables and connectors
Cables must be handled with care to avoid damage. Apply only the tension required to seat or unseat
cables during insertion or removal from the connector. Handle cables by the connector or pull-strap
whenever possible. In all cases, avoid bending or twisting the cables, and be sure that the cables are
routed in such a way that they cannot be caught or snagged by parts being removed or replaced.
CAUTION:
When servicing this workstation, be sure that cables are placed in their proper location
during the reassembly process. Improper cable placement can damage the workstation.
Hard drives
Hard drives are fragile, precision components. Therefore, you must avoid subjecting them to physical
shock and vibration. This guideline applies to failed drives and replacement drives and spares.
●
Do not remove hard drives from the shipping package for storage. Keep hard drives in their
protective packaging until they are actually mounted in the workstation.
●
Avoid dropping hard drives from any height.
●
If you are inserting or removing a hard drive, power off the workstation. Do not remove a hard drive
while the workstation is powered on or in standby mode.
●
Before handling a drive, be sure that you discharge static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, see
ESD
information on page 52
.
CAUTION:
To prevent possible ESD damage when the drive is installed, always connect the
drive power cable before connecting the data cable. This discharges accumulated static electricity
through the drive power cable to the workstation chassis.
●
Do not use excessive force when inserting a drive.
●
Avoid exposing a hard drive to liquids, temperature extremes, or products with magnetic fields such
as monitors or speakers.
Lithium coin cell battery
The battery included with the workstation provides power to the real-time clock and has a minimum
lifetime of about three years.
For instructions on battery removal and replacement, see
Battery on page 84
.
WARNING!
This workstation contains a lithium battery. There is a risk of fire and chemical burn if the
battery is handled improperly. Do not disassemble, crush, puncture, short the external contacts, dispose
of in water or fire, or expose the battery to temperatures higher than 60° Centigrade (140° Fahrenheit).
NOTE:
Batteries, battery packs, and accumulators should not be disposed of with general household
waste.
Customer Self-Repair
Customer Self-Repair enables you to obtain replacement parts and install them yourself on the
workstation. For more information, see:
http://www.hp.com/go/selfrepair/
.
56
Chapter 5 Removal and replacement procedures
ENWW
Содержание Xw4600 - Workstation - 2 GB RAM
Страница 1: ...HP xw4600 Workstation Service and Technical Reference Guide ...
Страница 10: ...x ENWW ...
