Heading
Option
Description
Multisector Transfers options are 8, 16, and Disable (16 is the default).
Transfer Mode specifies the active data transfer mode. Options (which are subject to device
capabilities) are: Max UDMA, PIO 0, Max PIO, Enhanced DMA, and Ultra DMA0 (Max UDMA is
the default).
Translation Mode enables the BIOS to automatically determine the translation mode used to
configure a previously formatted SATA or USB mass storage device. This prevents you from having
to know how the mass storage device was previously formatted.
Ordinarily, the translation mode selected automatically by the BIOS should not be changed. If the
selected translation mode is not compatible with the translation mode that was active when the
drive was partitioned and formatted, the data on the disk is inaccessible.
Translation Mode Options are: Automatic, Bit Shift, LBA Assisted, Use (Cylinders, Heads, Sectors),
and Off (Automatic is default).
Storage Options
Removable Media Boot—Enables and disables the ability to boot the system from removable
media.
Legacy Diskette Write—Enables and disables the ability to write data to removable media.
SATA Emulation—Sets the SATA emulation mode with the following options:
●
RAID–RAID OPROM executes. This emulation mode offers the best performance and most
functionality.
●
IDE–Offers standard SATA support (four ports only).
●
AHCI–Offers full SATA and SATA-II functionality with no support for RAID.
DPS Self-test
Enables you to select a drive test for a SATA drive. It is not displayed by default and not available
for RAID and AHCI configurations.
Boot Order
Enables you to configure the boot, diskette drive, and hard drive orders by physically reordering
the menu entries. The default boot order presents the following selections:
●
Optical Drive
●
Diskette Drive
●
USB Device
●
Hard Drive
●
Broadcom Ethernet controller
Press
Enter
to drag a device to a preferred place. Press
F5
to remove the device from consideration
as a bootable device.
NOTE:
MS-DOS drive lettering assignments might not apply after an operating system other than
MS-DOS has started.
Boot devices can be disabled in the boot order process. These order changes are stored in the
physical ROM when the F10 Setup changes are confirmed with File>Save Changes and Exit.
You can temporarily override the boot order:
To boot one time from a device other than the default device specified in Boot Order, restart the
workstation and press
F9
when the F9=Boot Menu message appears on the screen. After POST
completes, a list of bootable devices is displayed. Use the arrow keys to select the preferred
bootable device and press
Enter.
The workstation then boots from the selected nondefault device
this time only.
Security
Setup Password Enables you to set and enable setup (administrator) password.
NOTE:
If the setup password is set, it is required to change computer setup options, flash the
ROM, and make changes to certain Plug and Play settings under Windows.
Table 4-1
Computer Setup (F10) Utility menu descriptions (continued)
28
Chapter 4 System management
ENWW
Содержание Xw4600 - Workstation - 2 GB RAM
Страница 1: ...HP xw4600 Workstation Service and Technical Reference Guide ...
Страница 10: ...x ENWW ...
