HP Workstation xw3100, Сервисное и техническое руководство

Страница: 105 / 148

Service and Technical Reference Guide, xw3100 C–7
POST Error Messages
1998-Master Boot
Record has been
changed. The current MBR does not
match the previously
saved copy of the MBR. Use extreme caution, The MBR may have
been updated due to normal disk
maintenance activities (disk manager,
fdisk, or format). Replacing the
previously saved MBR in such situations
can cause data loss. If certain that the
MBR change is unintentional and
undesired (e.g. due to a virus), run
Computer Setup and restore the
previously saved MBR copy. Otherwise,
run Computer Setup and either disable
MBR security or save the MBR of the
current bootable disk.
2000-Master Boot
Record Hard Drive has
Changed. The current bootable hard
drive is not the same as
the one that was present
when MBR security was
enabled. Run Computer Setup and either disable
MBR security or save the MBR of the
current bootable disk.
Invalid Electronic Serial
Number. Electronic serial number
has become corrupted. Run Computer Setup. If Setup already
has data in the field or will not allow the
serial number to be entered, download
from http://www.hp.com and run
SP5572.EXE (SNZERO.EXE).
Run Computer Setup and try to enter
serial number under Security, System ID,
then save changes.
ECC Multiple Bit Error
Detected in Memory
Module. Chipset has detected
more than one bad bit in
a 64-bit quadword of the
memory array. Replace the memory module.
Parity Check 2. Parity RAM failure. Run Computer Setup and Diagnostic
utilities.
POST Error Messages
Screen Message Probable Cause Recommended Action