Set Basic Configuration Parameters using CLI Commands
6-15
set network names for each wireless interface
set network names for each wireless interface
set network names for each wireless interface
set network names for each wireless interface
– 3 = wireless card in Slot A
4 = wireless card in Slot B
[Device Name]>
set wif 3 netname <Network Name (SSID) for wireless card in Slot A>
[Device Name]>
set wif 4 netname <Network Name (SSID) for wireless card in Slot B>
[Device Name]>
show wif
<CR>
Figure 6-12
Figure 6-12
Figure 6-12
Figure 6-12 Results of “show wif” CLI command
Results of “show wif” CLI command
Results of “show wif” CLI command
Results of “show wif” CLI command
set wep encryption for each wireless interface
set wep encryption for each wireless interface
set wep encryption for each wireless interface
set wep encryption for each wireless interface
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
CAUTION:
!
Client stations must have the same encryption key to be able to communicate with the WL520 device. Each Wireless
Interface can only support one Key Length (so each of the configured keys must have the same length). The available
key sizes vary based on card type. See
Set WEP Encryption for each Wireless Interface
for more information.
for the wireless card in slot a
for the wireless card in slot a
for the wireless card in slot a
for the wireless card in slot a
You can set up to four encryption keys. This example describes setting encryption Key 1 on the wireless card in Slot A.
[Device Name]>
set wifsec 3 encryptstatus enable encryptkey1 <WEP key
(number of characters
vary depending on card type)
> encryptkeytx 1
[Device Name]>
show wifsec
<CR>
for the wireless card in slot b
for the wireless card in slot b
for the wireless card in slot b
for the wireless card in slot b
You can set up to four encryption keys. This example describes setting encryption Key 2 on the wireless card in Slot B.
[Device Name]>
set wifsec 4 encryptstatus enable encryptkey2 <WEP key
(number of characters
vary depending on card type)
> encryptkeytx 1
[Device Name]>
show wifsec
<CR>
