HP VMA Series, Инструкция по установке и обслуживанию

Страница: 48 / 300

Chapter 3 - Installing the Array
48
VMA-series Memory Array Installation and Service Guide HP-AM456-9002A Rev 01
Note:
The AC power cords are not a standard configuration. Use only the AC
power cords supplied with your system.
To connect the AC power cords to the system:
1.
Locate the AC power receptacles at the rear of the system, as shown in the
figure below.
Figure 3.6 AC Power Receptacle Locations
2.
Insert the power connector(s) into the mating power receptacle(s) on the
rear of the Memory Array.
3.
If using the cable management arm, route the power cord(s) according to
the instructions in
Routing the Cables onto the Cable Management Arm on
page 55.
Connecting Equipment Ground
Connect equipment ground from the equipment rack to the Memory Array only
after installing the system into the equipment rack.
Note:
• Use appropriately sized wire for your equipment application. Minimum
acceptable wire gauge is 8 AWG.
• Maintain reliable earthing of rack-mounted equipment. Supply extra
connections other than the direct connections to the branch circuit
(e.g., using power strips).
If ground cable included in accessory kit
1.
Using the 2.5 m (8.20 ft) ground cable supplied with the array, attach the
end of the cable with the lug installed to an appropriate grounding point on
the equipment rack. Use an appropriately sized screw to attach the ground
lug to the equipment rack.
LOC
A RAID
ADMIN
AC OK DC OK STAT
U
S
ALARM
B
Power
Supply A
Power
Supply B