HP VMA SAN, Руководство по установке и настройке

Страница: 57 / 83

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 57
1.
From the CLI, enter into Enable mode using the
enable
command and then Configure mode using the
configure terminal
command.
2.
All LUNs are created and managed within a container. To view the available containers, use
the show containers command.
Check the size of the containers. LUNs are implemented in 1 GB increments; the size of the
container may restrict the number of LUNs that may be created.
3.
Enter the
lun create
command to create LUNs within a container.
The command creates 20 LUNs of equal size in the container. Use the
nozero
option to ensure that
the data is not zeroed-out, which could take considerable time depending on the size of the
container.
Typically, fewer than 40 LUNs would be created within a container; however, the creation of up to
1024 LUNs is supported per container.
lun create Command
The
lun create
command enables you to create a LUN within a specified storage container
connected to the VMA SAN Gateway.
Syntax
[no] lun create container <container_name> name <LUN_name> size [<size GB>
| equal] [quantity <number>] [nozero] [readonly] [startnum <unsigned
integer>] [blksize 512 | 4096] [offline]
Syntax Description
The following table shows syntax for LUN commands.
> enable
# configure terminal
(config) #
> enable
# configure terminal
(config) # show containers
(config) # lun create container <container_name> name <LUN_name> size
equal quantity 20 nozero
name
Defines the name of LUN to be created; used as a prefix if the
quantity of LUNs created is greater than one.