HP Vectra XU 5/XX, Дополнительное руководство

Страница: 44 / 48

Vectra XU Familiarization Guide Troubleshooting and Repair
••
44
Parallel Port Parallel 1 (378 h,
IRQ7)
Parallel 2 (278 h,
IRQ5)
Off
Parallel Port Mode Centronics (R)
Bi-directional ECP
Bi-directional EPP If the peripheral has an
ECP EPP interface, use a
compatible cable
Serial Port Serial 1 (3F8 h, IRQ4)
Serial 2 (2F8 h, IRQ3)
Serial 3 (3E8 h, IRQ4)
Serial 4 (2E8 h, IRQ3)
Off They cannot be set to the
same address
REMOTE PROGRAM LOAD
Remote Start
Protocol
Specifies if a network is
used to load the computers
operating system
Specifies the type of
remote boot protocol
Ethernet Disabled
Not Used
LAN Manager
Ethernet
Novell Ethernet
If disabled the protocol
field defaults to Not Used
INTEGRATED ETHERNET INTERFACE
Integrated Interface
MAC Address
Enable or disable the
integrated Ethernet system
Address used by LAN
drivers
Enabled Disabled
Address displayed A unique identification
number used by the LAN
adapter(s). If the system
board is changed, the
LAN system administrator
must be informed.
Primary Adapter
Video BIOS
shadowing
Configures for the correct
video adapter
Allows Video BIOS to be
copied into main memory
EGA VGA or similar
Monochrome
CGA Multimode 80
CGA Multimode 40
Enabled Disabled
If the PC has a Matrox
video adapter board,
SETUP cannot be used
to configure the board.
If Video BIOS is used, it is
automatically copied into
main memory
640 x 480 mode
800 x 600 mode
1024 x 768 mode
1280 x 1024 mode
IRQ 9
IRQ 10
IRQ 11
IRQ 15
IRQ 12
If you've installed an ISA
board, this is used to tell
SETUP which IRQ the
board uses, and allows
PCI boards to be
configured automatically
60 72 Hz
72 75 Hz
70 75 87i* Hz
60 75 Hz
Used by ISA board
Available for PCI
Board(s)
Used by ISA board
Available for PCI
Board(s)
Used by ISA board
Available for PCI
Board(s)
Used by ISA board
Available for PCI
Board(s)
Used by Mouse
Available for Board(s)
If the PC has a Matrox
video adapter board,
SETUP cannot be used
to configure the board.
(Refer to chapter 2 of the
Setting Up Your PC
manual, supplied with the
PC.)
Always leave two IRQs
set as Available for PCI
Board(s)
IRQ12 is normally used
by the mouse
BIOS Version States BIOS Used Automatically detected