HP Synergy 480 Gen9, Руководство по техническому обслуживанию и ремонту, Страница: 32 / 71

5. Review the compute module front panel LEDs to determine the compute module status. For more
information on the compute module LEDs, see "
Component identification ."
Removing and replacing an access panel
To remove the component:
Procedure
1. Power down the compute module .
2. Remove the compute module .
3. Press the access panel release button.
4. Slide the access panel towards the rear of the compute module, and then lift to remove the panel.
To replace the component:
1. Place the access panel on top of the compute module.
2. Slide the access panel forward until it clicks into place.
Removing and replacing a drive blank
Remove the component as indicated.
1
2
32 Removing and replacing an access panel