HP StorageWorks Q2300, Руководство по установке

Страница: 25 / 42

Q2300 PCI-X host bus adapter for Itanium Linux systems installation guide 25
Building a ramdisk image to load the qla2300 driver
You can load the qla2300 driver at boot time using a ramdisk image as shown in this Red Hat EL
example.
1. For Red Hat EL, add the following line to the file
/etc/modules.conf
:
alias scsi_hostadapter qla2300
NOTE: If there are other SCSI host adapter boards installed on your system and the
scsi_hostadapter alias is used, define a different alias (for example,
scsi_hostadapter n
. The
n
is a number in the range 1 to 9).
2. Build a new ramdisk image that contains the
qla2300.o
object file.
You must copy the driver binary file
qla2300.o
to
/lib/modules/kernel_release_version/drivers/scsi.
NOTE: The
kernel_release_version
is the Linux kernel release version of your system.
3. Add the dependency for the qla2300 driver and build the ramdisk image:
You can either run
depmod -a
or make sure the following line is in the
/lib/modules/kernel_release_version/modules.dep
file:
/lib/modules/kernel_release_version/kernel/drivers/scsi/
qla2300.o: /lib/modules/kernel_release_version/kernel/
drivers/scsi/scsi_mod.o