HP StorageWorks NAS e7000 v2, Быстрый старт

Страница: 43 / 70

Configuration Setup
43 NAS e7000 v2 Quick Start Guide
Direct Access Method (Via Hostname)
The NAS e7000 v2 ships by default with DHCP enabled on the management port
(Eth 0). If the system is placed on a DHCP serviced network and the serial number
of the device is known, it can be accessed through a client running Microsoft
Internet Explorer 5.5 (or greater) on that network via the 3201 port of the device.
The serial number may be found on the front of the NAS e7000 v2.
Requirements
The following items are required to run the WebUI configuration application:
■
Windows-based PC loaded with Microsoft Internet Explorer 5.5 (or greater)
on the same segment as the NAS e7000 v2
■
DHCP-serviced network
■
DNS serviced network
■
Serial number of the NAS e7000 v2
Note: The NAS e7000 v2 is designed to be deployed without a monitor, keyboard,
and mouse. These ports are available and supported by the NAS device if used.
Procedure
To initialize the NAS e7000 v2 using the WebUI configuration application:
1. Connect the Ethernet cables to the respective network ports of the
NAS e7000 v2 and the corresponding network segments in accordance with
the information in the “Configuration Information” section in Chapter 2.
2. See Figure 6 and Table 3 for the locations of the network ports on the
NAS e7000 v2.
3. Go to the NAS device and power it on. It will be several minutes before the
NAS device is accessible on the network.
4. Open Internet Explorer on the Windows-based PC. Enter
http://
, the serial
number of the NAS e7000 v2 followed by a hyphen (
-
), followed by
:3201
.
Press Enter. This launches the WebUI configuration application (Rapid
Startup) on the target StorageWorks NAS device as shown in
Figure 9 .
Example:
http://D4059ABC3433-:3201