HP StorageWorks NAS e7000 v2, Быстрый старт

Страница: 22 / 70

Product Overview
22 NAS e7000 v2 Quick Start Guide
Setup and Configuration Overview
In setting up clustered and non-clustered systems, there is a well-defined process.
This section is intended as an overview of the process, and not a detailed list of
step-by-step instructions. Step-by-step procedures are documented in the
administration guide. Some of the steps are driven by the WebUI. In either type of
setup, it is important to read all of the supplied documentation prior to starting.
Relevant documents include:
■
Administration Guide
■
Online Cluster Install Guide in the Cluster Tab of the WebUI (Cluster Installs)
■
Online Storage Guide in the Cluster Tab of the WebUI (Cluster Installs)
■
Online SAN Connection Tool in the HP Utilities tab of the WebUI
■
Quick Reference Poster
■
Connection Poster
Standalone NAS e7000 v2
The following describes how to configure the NAS e7000 v2 as a single device.
1. Request Storage from the SAN administrator referencing the suggestions
made in this guide and the storage management section of the administration
guide. The LUNs will need to exist on the SAN prior to completing setup.
2. Initialize the NAS device using Chapters 2 and 3 from this guide.
3. Identify the firmware, storage network topology (hub vs. switch), and storage
controller features in use on the SAN. Prior to connecting any fiber cables,
utilize the SAN Connection tool included in the HP Utilities Tab of the
WebUI to configure the HBA and corresponding pathing software. Additional
information about the SAN connection tool may be found in Chapter 4 of this
guide
4. This is an optional step. Install NIC teaming software and create fault
tolerant or load balanced network ports. Follow the recommendations found
in this guide and in the administration guide.
5. Connect the fiber channel cables to the storage switch or hub. The SAN
administrator will need to enable the connections one at a time as the cables
are connected.