HP StorageWorks NAS e7000 v2, Быстрый старт

Страница: 19 / 70

Product Overview
19 NAS e7000 v2 Quick Start Guide
Connecting NAS e7000 v2 to the Network
The NAS e7000 v2 can be connected to the network as a single device or as a
clustered pair.
NAS e7000 v2 Single Device Deployment
In a single device deployment, network connections are divided into two
categories: client data segments and management segments. The default shipping
configuration contains a two-port network interface controller (NIC) 10/100 and a
single 10/100/1000 NC7770 NIC that together provide one port for management
and two ports for client data. The management port is intended for use with the
3201 port of the device to enable use of the Web User Interface (WebUI) that
accompanies the product. It is from this WebUI that most management and
administrative procedures can be accomplished. An additional management port
for remote console and diagnostics is provided off the Integrated Lights-Out (iLO)
port. HP recommends that this connection be placed on a management LAN
separate from the corporate infrastructure.
The NAS e7000 v2 supports the use of NIC teaming. NIC teaming provides
failover and load balancing of network ports of the NAS e7000 v2. NIC teaming
requires the network cables to be installed on the same subnet to enable it to work.
For example in
Figure 3 , Eth1 and Eth2 would need to be on the same subnet to
enable this functionality on those ports. However, it is not recommended to assign
IP addresses to the ports that will be teamed or load balanced prior to the
installation and setup of NIC teaming. For this reason, HP recommends that you
set all network ports to DHCP with the exception of Eth0, which is used for
management and only needs to meet the configuration policies of the corporation.
For information concerning the configuration of NIC teaming after setup is
complete, see the administration guide.