HP storageworks 2/32, Руководство по установке

Страница: 79 / 138

Installing and Configuring the Edge Switch 2/32
79 Edge Switch 2/32 Installation Guide
Enable Embedded Web Server
Use the following steps to enable EWS:
1. At the Hardware View page, choose Configure > Enable Web Server .
Choosing Enable Web Server automatically places a check mark in the
check box.
2. Choose Enable Web Server again to remove the check mark and disable the
EWS interface. When disabled, remote users cannot access the interface.
For complete information on using the EWS, refer to the HP StorageWorks
Embedded Web Server User Guide .
Enable Telnet
Use the following steps to enable Telnet:
1. At the Hardware View , choose Configure > Enable Telnet . Choosing
Enable Telnet automatically places a check mark in the check box.
2. Choose Enable Telnet again to remove the check mark and disable Telnet
access. When disabled, remote users cannot access the switch through Telnet.
Connect Cables to Fibre Channel Ports
Perform this task to connect devices to the switch. To cable Fibre Channel ports:
1. Route single mode or multimode fiber-optic cables (depending on the type of
SFP pluggable optic transceivers installed) from customer-specified devices
to ports at the front of the switch.
2. Connect device cables to small form factor pluggable (SFP) transceivers. Start
with port 0 and continue sequentially to the left through port 31.
3. Perform one of the following:
a. If the switch is installed on a table or desk top, bundle and secure the
Fibre Channel cables as directed by the customer.
b. If the switch is installed in an HP-supplied equipment rack, bundle Fibre
Channel cables from the switch and other equipment (groups of 16
maximum), and secure them as directed by the customer.
4. Set the switch online.