HP StorageWorks 2/140 - Director Switch, Руководство по обслуживанию, Страница: 29 / 396

General Information
29 Director 2/140 Service Manual
■
coldStart—Reports that the SNMP agent is reinitializing due to a director
reset.
■
warmStart—Reports that the SNMP agent is reinitializing due to a director
IPL.
■
authorizationFailure—Reports attempted director access by an unauthorized
SNMP manager. This trap is configurable and is disabled by default.
Director-specific SNMP traps specified in the custom MIB include Fibre Channel
port operational state changes and FRU operational state changes.
If authorized through the Configure SNMP dialog box in the Element Manager,
users at SNMP management workstations can modify MIB variables.
■
Director modifications performed through SNMP management workstations
are recorded in the associated director audit log and are available through the
Element Manager. For additional information, refer to the HP StorageWorks
SNMP Reference Guide for Directors and Edge Switches.
E-Mail and Call-Home Support
If e-mail notification and call-home support are configured for the director as part
of the customer support process, service personnel may be:
■
Notified of a director problem by e-mail message, either directly or through a
system administrator at the customer site or call center.
■
Assigned a service call from call center personnel upon receipt and
confirmation of a director call-home event.
Tools and Test Equipment
This section describes tools and test equipment that may be required to test,
service, and verify operation of the director and attached HAFM appliance. These
tools are either supplied with the director or must be supplied by service
personnel.
Tools Supplied with the Director
The following tools are supplied with the director. These tools may be required to
perform test, service, or verification tasks.