HP StorageWorks 1606 - Extension SAN Switch, Справочник по аппаратуре

Страница: 67 / 122

Table 11 FCoE Converged Network Switch port side LED patterns
Recommended action Status of hardware LED color LED name
Verify the following:
• System is powered on (power
supply switches to
1 ).
• The power cables are attached.
• The power source is live.
If the system power LED is not
green, the unit may be faulty.
Contact your switch service pro-
vider.
System is off or there is an intern-
al power supply failure. No light Power status
No action required. System is on and power supplies
are functioning properly. Steady green
Verify that the system is on and has
completed booting. System is off or there is no
power. No light System status
No action required. System is on and functioning
properly. Steady green
Perform the following steps:
1. Connect a serial cable to the
system.
2. Reboot the system.
3. Check the failure indicated on
the system console.
4. Contact your switch service
provider.
System is in an unknown state,
boot failed, or the system is
faulty.
Note:
This LED displays steady amber
during POST. This is normal and
does not indicate a fault. Steady amber (for
more than five
seconds)
Check the management interface
and the error log for details on the
cause of the status. Contact your
switch service provider. Attention is required. Several
variables can cause this status,
including a power supply fail-
ure, fan failure, or if one or
more environmental ranges have
been exceeded. Flashing amber
No action required. Port speed is 10 Mb/s. No light Ethernet speed
(Management
port)
No action required. Port speed is 100/1000 Mb/s. Steady green
Verify that the Ethernet cable is
connected properly. There is no link. No light Ethernet activ-
ity/Link (Man-
agement port)
No action required. There is a link. Steady green
No action required. There is link activity (traffic). Blinking green
Verify that the transceiver is in-
stalled correctly and the cable is
connected correctly. No light or signal carrier on
media interface Off Optical media
port status (two-
color LED for
each FC and
CEE port)
No action required. Receiving light or carrier, but
not online Steady amber
8-Gb SAN Switch Hardware Reference Guide 67