Diagnostic Tools
HP Servers Troubleshooting Guide
4-11
HP CONFIDENTIAL
Writer: Ted Weiman File Name: e-ch4 Diagnostic Tools.doc
Codename: Generic TSG Part Number: 161759-007 Last Saved On: 11/19/02 9:36 AM
•
If your server uses the System Configuration Utility (SCU):
a.
Power up the server, and then press the
F10
key when the following message
is displayed:
Press F10 for system partition utilities
b.
Select
Diagnostics and Utilities
from the SCU main menu.
c.
Select
Inspect Computer
to run Inspect.
If your system does not have a partition set up, a Diagnostics diskette is required to
run Inspect. To run Inspect from a Diagnostics diskette, boot the server with the
Diagnostics diskette in drive A. A Diagnostics diskette can be made by running the
Server Diagnostics file available for download from the following website:
www.compaq.com/support/files/server
Select your server and operating system, and then select the Server Diagnostics file
from the
Utilities
section on the website.
When Inspect has been initialized, select a hardware option for information about that
device.
Running Inspect on a 64-bit System
On a 64-bit system, Inspect can be run from within Diagnostics by selecting Inspect
Information from the main menu. Refer to the “Diagnostics on a 64-bit System”
section in this chapter for more information on running Diagnostics.
Inspect can also be run from the EFI Boot Manager. From the main menu in EFI
Boot Manager, select the
System Maintenance
menu, and then select
System
Inspect Menu
.