HP Sprout Pro, Руководство по обслуживанию и ремонту, Страница: 65 / 136

Outer plastic trim
The outer plastic trim is located around the edge of the computer.
To remove the outer plastic trim:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 23 ).
2. Remove the rear covers (see Removing the rear covers from the computer on page 24 ).
3. Remove the memory cover (see Memory on page 29 ).
4. Separate the computer from the column (see Separating the computer from the column on page 41 ).
5. Remove the four longer corner Torx screws (1) and the two shorter middle Torx screws (2).
6. Pry around the edges of the outer trim to disengage it from the computer (3).
To install the outer plastic trim, reverse the removal procedures.
Outer plastic trim 55