HP Slate 10 Plus, Руководство по техническому обслуживанию и ремонту

Страница: 31 / 40

2. Remove the rear-facing webcam (2) and cable.
Reverse this procedure to install the rear-facing webcam.
System board
Description Spare part number
System board equipped with a Balong V9R1 Cortex-A9 quad core 1.60-GHz processor, 1.0-GB
of system memory, 8-GB eMMC system storage, and a graphics subsystem with UMA memory 776019-001
Before removing the system board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display panel assembly (see Display panel assembly on page 15 ).
5. Remove the connector board (see Connector board on page 19 ).
6. Disconnect the battery cable from the system board (see Battery on page 20 ).
7. Remove the left and right speaker connector boards (see Speaker connector boards on page 21 ).
Remove the system board:
1. Lift the outside edge of the system board (1) until it rests at an angle.
System board 25