Removal and replacement procedures 38
12.92 kg
28.48 lb
This symbol indicates that the component exceeds the recommended weight for one
individual to handle safely.
WARNING:
To reduce the risk of personal injury or damage to the equipment,
observe local occupational health and safety requirements and guidelines for manual
material handling.
These symbols, on power supplies or systems, indicate that the equipment is
supplied by multiple sources of power.
WARNING:
To reduce the risk of injury from electric shock, remove all power cords
to disconnect power from the system completely.
Warnings and cautions
Before installing a server, be sure that you understand the following warnings and cautions.
WARNING:
To reduce the risk of electric shock or damage to the equipment:
•
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
•
Connect the power cord into a grounded (earthed) electrical outlet that is easily accessible
at all times.
•
Disconnect the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord extends
from the rack.
CAUTION:
Do not operate the rack for long periods with the access panel open or removed.
Operating the rack in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
Preparation procedures
To access some components and perform certain service procedures, you must perform one or more of
the following procedures:
•
Remove the access panel (on page
•
Install the access panel (on page
•
Remove the server from the rack ("
•
Install the server into the rack ("
Server blank
CAUTION:
Always install a server or server blank in each slot in the rack. Failure to do so
results in improper airflow that can lead to a decrease in thermal performance.
To remove the component:
Содержание ProLiant XL730f Gen9 Server
Страница 8: ...Component identification 8 Server numbering in rack Serial label pull tab ...
Страница 14: ...Operations 14 2 Slide the access panel toward the front of the server The access panel locks into position ...
Страница 68: ...Acronyms and abbreviations 68 UEFI Unified Extensible Firmware Interface UID unit identification ...
