HP ProLiant WS460c Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 42 / 102

Removal and replacement procedures 42
9.
Disengage the four heatsink screws and remove the heatsink. Be sure to hold the heatsink bracket
in place on the bottom of the MXM board.
To replace the component, reverse the removal procedure.
PCIe graphics card options
PCIe graphics cards are supported on the expansion module and installed in expansion blade PCIe
card cage. The procedure for replacing graphics cards on the single-width blade is different. For more
information, see "Mezzanine options (on page 35 )."
Required tools for this procedure:
•
T-10/T-15 Torx screwdriver
•
Insight Diagnostics software
For a complete list of supported options, see the product QuickSpecs on the Hewlett Packard
Enterprise website ( http://www.hpe.com/info/qs ).
Removing the PCIe graphics card options
To remove the graphics cards from the graphics expansion module:
1.
Power down the graphics server blade (on page 25 ).
2.
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
3.
Remove the expansion blade access panel (" Expansion blade access panel " on page 31 ).
4.
Remove the expansion blade front bezel (" Remove the expansion module front bezel " on page
29 ).
5.
Remove the foam gasket (on page 27 ).
6.
Disconnect the power cable from the expander power board and the PCI graphics option.
7.
Remove the graphics expansion control cable.
8.
Remove the retaining block (on page 29 ).
9.
Remove the expansion blade PCIe card cage (on page 28 ).