HP ProLiant StorageWorks NAS 1500s, Руководство по установке

Страница: 33 / 54

NAS 1500s Installation Guide 33
Direct attach method
You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the NAS 1500s.
Procedure
To initialize the NAS 1500s:
1. Connect the Ethernet cables to the respective network ports
of the NAS 1500s and the corresponding network segments.
2. Connect the monitor, mouse, and keyboard directly to the rear
panel connectors of the NAS 1500s. See Figure 2 and Table 2
for the locations of the connectors on the NAS 1500s.
3. Open Internet Explorer to launch the WebUI configuration
application (Rapid Startup) on the target NAS device, as
shown in
Figure 8 . If the WebUI does not launch connect to
the LocalHost and login to the WebUI.
Note: The default login for the WebUI is
administrator
and the
password is
hpinvent
. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
4. Go to “ Rapid Startup Wizard configuration ” on page 34 to
complete the setup procedures.