HP ProLiant SL390s G7 2U, Руководство пользователя

Страница: 43 / 85

Configuration and utilities 43
The ROMPaq utility checks the system and provides a choice (if more than one exists) of available firmware
revisions.
For more information, go to the HP website Drivers, Software
& Firmware . Then, enter your product name in the Find an HP product field and click Go .
To access the server-specific page for this server, enter the following web address into the browser:
http://www.hp.com/support/sl390sg7
Integrated Lights-Out 3 technology
The iLO 3 subsystem is a standard component of selected ProLiant servers that provides server health and
remote server manageability. The iLO 3 subsystem includes an intelligent microprocessor, secure memory,
and a dedicated network interface. This design makes iLO 3 independent of the host server and its operating
system. The iLO 3 subsystem provides remote access to any authorized network client, sends alerts, and
provides other server management functions.
Using iLO 3, you can:
•
Remotely power up, power down, or reboot the host server.
•
Send alerts from iLO 3 regardless of the state of the host server.
•
Access advanced troubleshooting features through the iLO 3 interface.
•
Diagnose iLO 3 using HP SIM through a web browser and SNMP alerting.
For more information about iLO 3 features (which may require an iLO Advanced Pack or iLO Advanced for
BladeSystem license), see the iLO 3 documentation on the Documentation CD or on the HP website
Erase Utility
CAUTION: Perform a backup before running the System Erase Utility. The utility sets the system
to its original factory state, deletes the current hardware configuration information, including
array setup and disk partitioning, and erases all connected hard drives completely. Refer to the
instructions for using this utility.
Run the Erase Utility if you must erase the system for the following reasons:
•
You want to install a new operating system on a server with an existing operating system.
•
You encounter an error when completing the steps of a factory-installed operating system installation.
To access the Erase Utility, use the System Erase button on the home screen of the SmartStart CD (" SmartStart
software " on page 38 ).
HP ProLiant SL Advanced Power Manager
HP ProLiant SL Advanced Power Manager is a single point of contact for HP ProLiant Scalable System
administration.
HP ProLiant SL Advanced Power Manager enables:
•
Discovery of server rack components by topology
•
Node-level power monitoring and control