HP ProLiant SL210t Gen8, Руководство пользователя

Страница: 42 / 103

Hardware options installation 42
c.
Disconnect and remove the Mini-SAS cable (" Remove the Mini-SAS cable " on page 23 ).
5.
In a 2U node configuration:
a.
Remove the PCI riser cage (on page 20 ).
b.
Remove the 2U adapter board bracket (on page 22 ).
c.
Disconnect and remove the Mini-SAS cable (" Remove the Mini-SAS cable " on page 23 ).
d.
Remove the 2U air baffle (on page 26 ).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
In a 1U node configuration:
a.
Connect the Mini-SAS cable (on page 24 ).
b.
Install the 1U air baffle (on page 28 ).
c.
Install the 1U cable guard (on page 19 ).
9.
In a 2U node configuration:
a.
Install the 2U air baffle (on page 26 ).
b.
Connect the Mini-SAS cable (on page 24 ).
c.
Install the 2U adapter board bracket (on page 23 ).
d.
Install the PCI riser cage (on page 21 ).
10.
Install the node into the chassis (" Installing a node into the chassis " on page 30 ).
11.
Connect all peripheral cables to the node.
12.
Power up the node (" Power up the nodes " on page 17 ).
To configure the memory mode, use RBSU (" HP ROM-Based Setup Utility " on page 75 ).
Expansion board options
Installing an expansion board