Diagnostic Tools and Setup Utilities
HP ProLiant ML150 Generation 2 Server Maintenance and Service Guide
3-11
HP CONFIDENTIAL Codename: Stone Soup 2 Part Number: 368148-003 Last Saved On: 4/19/05 5:18 PM
SCSI Configuration Utility
The HP server uses the SCSISelect Utility to verify or modify the SCSI controller settings for
the devices connected to the system board. If you need to verify or modify SCSI controller
settings, or if you need to low-level format SCSI disks or verify SCSI disk media, run the
SCSISelect Utility.
NOTE: You typically would not need to use this utility unless you are an experienced administrator or
requested to do so by a support provider.
Starting SCSISelect
1.
Power up the server and monitor.
During the startup process, pay careful attention to the messages that display on your
screen.
2.
When the following message displays on your screen, press the Ctrl-A keys
simultaneously (this message displays for only a few seconds):
Press <Ctrl><A> for SCSISelect(TM) Utility!
3.
From the menu that displays, use the arrow keys to select the controller, and press the
Enter key.
Figure 3-8: Controller menu of the SCSISelect Utility
