HP ProLiant DL60 Gen9, Руководство пользователя

Страница: 20 / 127

Operations 20
To remove the component:
1.
Power down the server (on page 15 ).
2.
If you are performing a non-hot-plug procedure, remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o Extend the server from the rack (on page 15 ).
o
Remove the server from the rack (on page 18 ).
4.
Remove the access panel (on page 18 ).
5.
Remove the air baffle.
l
Install the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.