Installing Hardware Options
WARNING: The system power in the ProLiant DL580 Generation 2 server does
not shut off completely from the front panel Power On/Standby button. The two
positions function as on and standby, rather than on and off. The standby
position removes power from most of the electronics and the drives; however,
portions of the power supply and some internal circuitry remain active.
To remove all power from the system, it is necessary to disconnect the power
cord from the server. In systems with multiple power supplies, disconnect all
the power cords to remove power from the system.
Locating and Removing the Torx T-15 Tool
Many hardware procedures in the ProLiant DL580 Generation 2 server are toolless,
but a few require the removal of Torx T-15 screws that have been installed for
shipping or security reasons. A Torx T-15 tool ships with the server for the removal
of these screws.
To locate and remove the Torx T-15 tool:
1.
Locate the Torx T-15 tool on the back of the server. It is next to PCI-X slot 6.
2.
Slide the tool out of the retaining clips.
Figure 5-3: Locating and removing the Torx T-15 tool
5-8
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Karen Hale File Name: f-ch5 Installing Hardware Options.doc
Codename: Dwarf Part Number: 230835-003 Last Saved On: 6/26/03 9:31 AM
