HP ProLiant DL580 G2, Руководство пользователя

Страница: 37 / 73

manage the volumes residing on dynamic disks. Other options include the
ability to delete, extend, mirror, and repair these elements.
NOTE:
See the section “Dynamic growth” in the administration guide for
additional information on LUN extension and use by the operating system.
Partitions
Partitions exist as either Primary Partitions or Extended Partitions and can
be composed of only one basic disk no larger than 2 TB. Basic disks can
also only contain up to four primary partitions, or three primary partitions
and one extended partition. In addition, the partitions on them cannot be
extended beyond the limits of a single LUN. Extended partitions allow
the user to create multiple logical drives. These partitions or logical disks
can be assigned drive letters or be mounted as mount points on existing
disks. If mount points are utilized, it should be noted that Services for UNIX
does not support mount points at this time. The use of mount points in
conjunction with NFS shares is not supported.
Volumes
When planning dynamic disks and volumes there is a limit to the amount of
growth a single volume can undergo. Volumes are limited in size and are
limited to no more than 32 separate LUNs with each LUN not exceeding 2
terabytes (TB). Volumes also cannot exceed 64 TB of disk space.
The RAID level of the LUNs included in a volume must be considered. All
of the units that make up a volume should have the same high-availability
characteristics. In other words, the units should all be of the same RAID
level. For example, it would be a bad practice to include both a RAID 1+0
and a RAID 5 array in the same volume set. By keeping all the units the
same, the entire volume retains the same performance and high-availability
characteristics, making managing and maintaining the volume much
easier. If a dynamic disk goes of fl ine, the entire volume dependent on the
one or more dynamic disks is unavailable. There could be a potential for
data loss depending on the nature of the failed LUN.
Volumes are created out of the dynamic disks and can be expanded on
the fl y to extend over multiple dynamic disks if they are spanned volumes.
However, after a type of volume is selected it cannot be altered. For
example, a spanning volume cannot be altered to a mirrored volume
without deleting and recreating the volume, unless it is a simple volume.
Simple volumes can be mirrored or converted to spanned volumes. Fault
tolerant disks cannot be extended either. Therefore, selection of the volume
HP ProLiant Storage Server user guide 37