5. Be sure no POST error messages are displayed while booting the server that indicate
temperature violation or fan failure information.
6. Check the LEDs to be sure the hot - plug fans are working.
7. Be sure hot - plug fan requirements are being met
Next steps
If the part is defective, continue with the following removal and replacement procedures.
Replacing thermal fans
About this task
Follow the steps below to replace the DL360p G8 SRVR FAN FRU.
Note:
Always follow safe electrostatic discharge practices.
Procedure
1. Replace any required non - functioning fans and restart the server if necessary. Fans are
hot-swappable.
2. To remove the component:
a. Extend the server from the rack. If the server is to remain on with application up, ensure
power cord does not disconnect when extending server from rack.
b. Remove the access panel
c. Remove the fan module.
Maintaining and Troubleshooting the HP DL360p G8 Server
30
Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server
September 2013
