HP ProLiant DL170h G6 Server
HP ProLiant DL170h G6 Server
HP ProLiant DL170h G6 Server
HP ProLiant DL170h G6 Server
NOTE:
NOTE:
NOTE:
NOTE: Memory configurations listed do not apply to "Factory Integrated Models".
Standard Memory
Standard Memory
Standard Memory
Standard Memory
6GB (3 x 2GB)/server node, PC3-10600E Unregistered DIMM memory, with ECC
Maximum Memory
Maximum Memory
Maximum Memory
Maximum Memory
Up to 192GB, using PC3-8500R DDR3 Registered (RDIMM) memory, operating at 800MHz when fully populated at 2 DIMMs per
Channel in 12 slots
Up to 48GB, using PC3-10600E DDR3 Unbuffered (UDIMM) memory, operating at 1333MHz when fully populated at 2 DIMMs per
Channel in 12 slots
NOTE:
NOTE:
NOTE:
NOTE: RDIMMs and UDIMMs cannot be in the same system so the maximum RDIMM memory configuration can only be achieved
with BTO models by replacing all of the UDIMMs.
NOTE:
NOTE:
NOTE:
NOTE: Chart does not represent all possible memory configurations.
DDR3 memory population guidelines
DDR3 memory population guidelines
DDR3 memory population guidelines
DDR3 memory population guidelines
For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool:
www.hp.com/go/ddr3memory-configurator
Some DIMM installation guidelines are summarized below:
For servers with sixteen (16) memory slots
There are three (3) channels per processor; six (6) channels per server
There are two (3) DIMM slots for two memory channels and one (2) DIMM slots for one memory channel; sixteen (16) total
slots
Memory channel 1 consists of the two (2) DIMM slots that are closest to the processor
Memory channels 2 and 3 consist of the six (6) DIMM slots that are furthest from the processor
DIMM slots that are white should be populated first
Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs)
Do not install DIMMs if the corresponding processor is not installed
If only one processor is installed in a 2CPU system, only half of the DIMM slots are available
To maximize performance, balance the total memory capacity between all installed processors
It is not required, but it is recommended to load the channels similarly if possible
You can only have up to eight (8) ranks installed per channel
You can only install two quad-rank DIMMs per channel
You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty
Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel
Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset
Low Voltage DIMMs can only be used with Intel Xeon 5600 series processors.
For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically
For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots
will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system
If mixing DIMM voltage is a requirement, please note that the DIMMs will run at 1.5V since all 1.35V are capable of
supporting 1.5V operations.
QuickSpecs
HP ProLiant DL1000 Multi Node Server
HP ProLiant DL1000 Multi Node Server
HP ProLiant DL1000 Multi Node Server
HP ProLiant DL1000 Multi Node Server
Memory
DA - 13309 Canada — Version 31 — April 8, 2011
Page 35
