HP ProLiant BL685c G7, Руководство по техническому обслуживанию и ремонту

Страница: 34 / 67

Removal and replacement procedures 34
3.
Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
4.
Install the front panel/hard drive cage assembly (" Front panel/hard drive cage assembly " on page
30 ), if removed.
5.
Install the hard drives (" Hard drive " on page 25 ), if removed.
6.
Install the access panel (" Access panel " on page 24 ).
Processor
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction, do not mix processors of different speeds or
cache sizes. Refer to the label on the processor heatsink for a description of the processor.
CAUTION: The server blade supports only two- or four-processor configurations. Always
populate processor sockets 1 and 2 with processors and heatsinks. To prevent overheating,
always populate processor sockets 3 and 4 with processors and heatsinks or processor socket
covers and heatsink blanks.
To remove the component:
1.
Power down the server blade (on page 22 ).
2.
Remove the server blade (on page 23 ).
3.
Remove the access panel (" Access panel " on page 24 ).
4.
To remove heatsink 3 or 4, perform these additional steps:
a.
Remove all hard drives (" Hard drive " on page 25 ), if installed.
b.
Remove the front panel/hard drive cage assembly (" Front panel/hard drive cage assembly " on
page 30 ).
5.
Remove the heatsink (" Heatsink " on page 32 ).