HP ProLiant BL685c G6, Руководство по техническому обслуживанию и ремонту, Страница: 25 / 70

Removal and replacement procedures 25
3.
Remove the server blade.
4.
Place the server blade on a flat, level work surface.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
HP Trusted Platform Module
The TPM is not a customer-removable part.
CAUTION: Any attempt to remove an installed TPM from the system board breaks or disfigures
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to
ensure the integrity of the system data.
If you suspect a TPM board failure, leave the TPM installed and remove the system board (" System board "
on page 44 ). Contact an HP authorized service provider for a replacement system board and TPM board.
Access panel
To remove the component:
1.
Power down the server blade (on page 24 ).
2.
Remove the server blade (on page 24 ).
3.
Press the access panel release button, and then slide the access panel to the rear.
4.
Remove the access panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.