HP ProLiant BL460c Gen9, Руководство пользователя

Страница: 52 / 90

Hardware options installation 52
o
Install the storage controller/NVMe pass-through board.
o
Install the direct connect SATA cable (on page 19 ).
15.
If removed, install the internal USB drive. To locate the internal USB connector, see "System board
components (on page
11 )."
16.
Install the access panel (on page 16 ).
17.
Install the server blade (on page 28 ).
18.
Power up the server blade (on page 14 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server blade.
•
Do not save the recovery key/password on the encrypted hard drive.
Enabling the Trusted Platform Module
1.
During the server blade startup sequence, press the F9 key to access System Utilities.
2.
From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Server Security .
3.
Select Trusted Platform Module Options and press the Enter key .
4.
Select Enabled to enable the TPM and BIOS secure startup. The TPM is fully functional in this
mode.
5.
Press the F10 key to save your selection.
6.
When prompted to save the change in System Utilities, press the Y key.
7.
Press the ESC key to exit System Utilities. Then, press the Enter key when prompted to reboot the
server blade.
The server blade then reboots a second time without user input. During this reboot, the TPM setting
becomes effective.
You can now enable TPM functionality in the OS, such as Microsoft Windows BitLocker or measured
boot.
CAUTION: When a TPM is installed and enabled on the server blade, data access is locked
if you fail to follow the proper procedures for updating the system or option firmware, replacing
the system board, replacing a hard drive, or modifying OS application TPM settings.
For more information on firmware updates and hardware procedures, see the HP Trusted Platform
Module Best Practices White Paper on the Hewlett Packard Enterprise Support Center website
( http://www.hpe.com/support/hpesc ).
For more information on adjusting TPM usage in BitLocker, see the Microsoft website
(
http://technet.microsoft.com/en-us/library/cc732774.aspx ).