Removal and Replacement Procedures
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
2-9
Hot-Plug SCSI Hard Drives
To assess hard drive status, observe the hot-plug SCSI hard drive status LEDs. For a detailed
explanation of these LEDs, refer to Chapter 4, “Connectors, LEDs, and Switches.”
CAUTION:
Refer to the
HP ProLiant Servers Troubleshooting Guide
before removing a hard
drive.
IMPORTANT:
It is not necessary to power down the server blade before removing or replacing a
hot-plug SCSI hard drive.
To remove a hot-plug SCSI hard drive:
1.
Press the port-colored release button (1).
2.
Open the ejector lever (2).
3.
Slide the drive out of the drive cage (3).
Figure 2-5: Removing a hot-plug SCSI hard drive
CAUTION:
Always populate hard drive bays with either a hot-plug SCSI hard drive or hard
drive blank. Operating the server blade without a hot-plug SCSI hard drive or hard drive blank
results in improper airflow and improper cooling that can lead to thermal damage.
To replace a hot-plug SCSI hard drive:
1.
Slide the drive into the cage until it is fully seated.
2.
Close the lever, locking the drive into place.
