The Configuration Menu
6-28
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
HP CONFIDENTIAL
Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
NOTE:
If the TFTP server is running SunOS™ or the Solaris™ operating system, the specified
ptcfg
file must exist prior to executing the
ptcfg
command and must be writable (set with proper permission,
and not locked by any application). The contents of the specified file will be replaced with the current
configuration data.
Restoring the Active GbE2 Interconnect Switch Configuration
Command:
/cfg/gtcfg
<TFTP server> <filename>
When the
gtcfg
command is used, the active configuration will be replaced with the
commands found in the specified configuration file. The file can contain a full GbE2
Interconnect Switch configuration or a partial configuration. The configuration loaded using
gtcfg
is not activated until the
apply
command is used. If the
apply
command is found in the
configuration script file loaded using this command, the apply action will be performed
automatically.
To start the GbE2 Interconnect Switch configuration download, at the
Configuration#
prompt, enter:
Configuration#
gtcfg
<
TFTP server>
<filename>
Where
<TFTP server>
is the TFTP server IP address or hostname, and
<filename>
is the
name of the target script configuration file.
NOTE:
The GbE2 Interconnect Switch supports three configuration files: active, backup, and factory.
Refer to the “Selecting a Configuration Block” section in Chapter 8, The Boot Options Menu, for
information on how to set which configuration file to use upon bootup.